09 Mar 10

I want biometric instruments.

09 Mar 10

We are looking for conductive pen (micro tip) for repairing of carbon traces.

02 Mar 10

75KVA D.G SET AMF PANEL.

23 Feb 10

We Require PLC's. Our details of Require For PLC's Is As Below : 1.OUR VOLUMETRIC SENSOR IS A THREE WIRED OUTPUT PARAMETER,WHICH WILL GIVE 4-20ma OUTPUT(INPUT1),INPUT 2 i.e.PRESSURE TRANSMITTER WILL GIVE TWO WIRE 4-20mA OUTPUT,INPUT 3 PARAMETER i.e.TEMPERATURE TRANSMITTER WILL GIVE SAME 4-20mA OUTPUT IN TWO WIRES THIS THREE INPUTS WILL BE CONNECTED IN YOUR INSTRUMENT.THAT INSTRUMENT WILL CALCULATE BY THE GIVEN FORMULA & GIVE THE CUMULATIVE READOUTS IN LITRES,THIS READOUTS WILL GO IN THE COMPUTER VIA MODBUS RTU PROTOCOL .WHEN WE ENTER THE ADDRESSES IN THE INPUT REGISTER THE READOUT IN LITRES SHOULD BE SEEN ALONG WITH THE THREE PARAMETERS i.e INPUT1,2,3 INDEPENDENTLY. 2.We Require Min.15 Nos Of PLC's Per Month But The quantity Can Be increased . 3.We Require Density Meters To Be Used In Milk,LPG,BIO GAS Gases,The Density Meters Should Be A Food Graded One.

20 Feb 10

Our Requirements are as follows: Slurry Mix : Lead Sub Oxide,Sulphuric acid-1.3 to 1.5(Sp.gr) and DI Water Tank Ht : 2 Mt Tank Dia 1 Mt Temperature : Max 60°C Density : 1.1 to 3.0 gm/cc Stirrer RPM : Max 50 Tank with continuous vibration,and continuous rotation slurry will be corrosive and sticky in nature and not easy to clean. MOC : MS with FRP lining Required : Non-contact type level indicator.